The ultimate paramotor smoke system. Designed from end to end for PPG applications.

It’s not an RC airplane pump or a window washer fluid pump. There are no lipo batteries (fire hazard) or separate lipo battery chargers required. Our PPG smoke system is a ball bearing based, high flow rate, low energy consumption pump - specifically designed paramotor applications. Lightweight, small form-factor and single piece housing design with an on and off switch and on/off button. Lasts up to 4 hours on rechargeable AA batteries or 120 flights.

Compatible with diesel, aircraft smoke oil or baby oil. Installation and setup takes about 30 minutes.


  • 1000 ml fluid container
  • 500 ml per minute flow rate
  • 2 minutes of smoke per flight
  • 4 hours or 120 flights of battery life
  • 12v input


  • Smoke Pump
  • Smoke Fluid Mount
  • Smoke Hardware Kit


  • Rivnut gun
  • 4 AA batteries
  • 7MM drill bit
  • 450° high temp. threadlock

Limited Quantities Available!

Current Stock:
12.00 (in)
5.00 (in)
5.00 (in)
Shipping Cost:
Calculated at Checkout

No Reviews Write a Review